The SH-8014 hydraulic shear from Baileigh industrial is a great shear for those fabrication shops that mainly work with smaller gauge sheet metal. The SH-8014 metal shear from Baileigh Industrial has an 80" cutting width and can shear up to 14 gauge mild steel. The table of the SH-8014 hydraulic shear is made from ground and polished steel plate allowing enough rigidity to shear at full capacity over and over again. The SH-8014 hydraulic shear can also cut through 18 gauge stainless steel.
Operating on 220 volt three phase power, the industrial grade hydraulics pull the top shearing head with top blade smoothly through the material being cut increasing blade life. The SH-8014 shear has top and bottom blades have multiple cutting edges that extends blade life. The SH-8014 features hydraulic hold downs that hold the sheet metal firmly against the in feed table eliminating any lifting of material as it is cut which improves blade life.
The SH-8014 hydraulic metal shear has a manual back gauge or material stop as well as front support arms to help the operator handle the sheet metal and provide for repeatable shearing. The operator control panel has a switch that allows the fabricator to jog the blade, for accurate blade adjustment, or go into an automatic mode that is initiated by the foot pedal control.
Contact a Baileigh Industrial representative for more information on the SH-8014.
Back Gauge Length 24" Shear Length 80" Motor 3 hp Thickness (SS) 14 ga. (18 ga.) Strokes Per Minute 26 Front Gauge Length 24" Blade Angle 1° Power 220V / 3-phase Shipping Weight 3,700 lbs. Shipping Dimensions 104" x 36" x 53"
* specifications subject to change without notice.